Step-by-Step Installation Guide
PREPARATION (First Time Application)
1. Clean Your Lens Thoroughly
- Remove respirator/mask lens from equipment (if removable)
- Clean lens with mild soap and water or provided prep solution
- Dry completely with lint-free cloth (included if applicable)
- Ensure surface is free from dust, oil, and fingerprints
- Tip: For best results, apply in a clean, dust-free environment
2. Inspect the Protective Film Stack
- Remove one 7-layer stack from packaging
- Identify the liner/backing layer (white liner)
- Do not separate the individual layers – they apply as a single unit
- Check that all layers are aligned properly
APPLICATION
1. Position and Align
- Hold the stack with the backing liner facing away from the lens
- Align the protector with your lens edges (use alignment guides if available)
- Start at one edge – avoid touching the adhesive side
2. Apply the Stack
- Gently press one edge of the stack to the lens surface
- Slowly smooth across the lens using a squeegee motion with your hand or provided applicator
- Work from center outward to eliminate air bubbles
- Apply firm, even pressure across entire surface
3. Remove Backing Liner
- Locate the pull tab on the backing liner
- Peel back slowly and steadily at a 180-degree angle
- If you see air bubbles, gently lift and reapply that section
- The 7-layer stack is now installed and ready for use
TEAR-OFF OPERATION (During Work)
1. When Your Lens Gets Dirty
- Locate the tear-off tab at the edge of the top layer
- Grip the tab firmly with your thumb and index finger
- Pull quickly and smoothly in one continuous motion
- Tear-away layer will peel off completely, revealing fresh layer underneath
2. Continue Working
- Immediately resume work with clear vision – no downtime required
- Repeat tear-off process as needed (up to 7 times per application)
- When all 7 layers are used, apply a new stack following steps 1-5
